Dynalco SWT-2000 Speed Switch/Speed Transmitter Instrukcja Użytkownika Pobierz pdf (Strona 13)

Operating Instructions SWT-2000 DYNALCO

4. Installation

The SWT-2000 may only be installed by competent personnel. Only undamaged and correctly configured units

may be used.

Before switching on, check that the supply is within the permissible range.

The Sensor cable screens must be connected terminals „Sh1“ and „Sh2“ respectively so as to minimize the

effects of signal noise. These terminals are internally connected with 0V.

Attention: If the password has been changed, there is no way of returning to a factory setup. If the password

is forgotten, the unit will need to be returned to Dynalco for re-programming.

5. Connections

5.1 Front View

5.1.1 Front View SWT-2000

The Ethernet Interface, status LED along with the FUNC push button are located at the front. For

communications, see Paragraph 6 Configuration via PC Software

Terminal B

Terminal A

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 34 35

Brak uwag

Dynalco SWT-2000 Speed Switch/Speed Transmitter Instrukcja Użytkownika Strona 13