Dynalco SWTD-1000 Speed Switch/Transmitter Instrukcja Użytkownika Strona 16
- Strona / 22
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
Operating Instructions SWTD-1000 DYNALCO
14//
8.5 Parameters
Parameters are changed in the sub menus from the drop down menu “Configuration“.
Warning:
New configurations only become active after being downloaded into the SWTD-1000 via:
SWTD-1000 Æ Write Parameters
8.5.1 System Parameters (Configuration Æ System)
Machine Factor
The machine factor establishes the relationship between sensor frequency and associated speed.
Machine Factor = Frequency
RPM
See section
4.2 Machine Factor.
Once the correct machine factor is entered, all other settings e.g limits are made in RPM.
Minimum Measuring Time
The minimum measuring time determines the time during which the input frequency is measured. Once
this time has lapsed, the calculation is made following the end of the running signal period. The
minimum measuring time may be increased to filter out frequency jitter so as to display a stable reading
but at the cost of increased reaction time.
Minimum Displayed Value
The minimum displayed value is a measured value under which “0000” is displayed.
Alarm Definition
This function defines the alarm. It may be only system error or a logical OR combination of system error
OR sensor monitoring. During an alarm the LED is off. In addition, the relay is deactivated and the
analog output goes to 0mA irrespective of the output range.
8.5.2 Sensor Parameter (Configuration Æ Sensor)
Sensor Type
The type of sensor to be used is defined here.
<Sensor active>
is for monitoring sensors powered by SWTD-1000 including 2 wire sensors supplied via
the internal pull up resistor. (Jumper J1).
<Sensor passive>
is for monitoring non powered sensors e.g. 2 wire VR (passive) sensors.
See also section 0 9.4.1 Sensor Fault (Sensor Monitoring).
Sensor Iinput
The sensor input “analog” (Sign) or “digital” (IQ) is defined here.
Sensor Current Minimum
As long as the sensor current consumption lies above the value <Current Minimum>, the sensor is
considered to be functioning correctly.
Sensor Current Maximum
As long as the sensor current consumption lies below the value <Current Maximum>, the sensor is
considered to be functioning correctly.
- SWTD-1000 1
- Speed Switch / Transmitter 1
- TABLE OF CONTENTS 2
- 1. Safety Instructions 3
- 2. Product Features 3
- 3. Specifications 4
- 3.2 Inputs 5
- 3.2.3 Sensor Supply 6
- 3.3 Outputs 7
- 3.4 Data Communication 8
- 3.5 Environment 8
- 4. Principle of Operation 9
- 4.2 Machine Factor 10
- 5. Installation 11
- 6. Connnections 11
- 7. Hardware Configuration 13
- 8.1 Software Concept 14
- 8.2 PC Communications 14
- 8.3 PC Software Settings 14
- 8.5 Parameters 16
- (minimal measured 17
- 9. Operating Behavior 19
- 9.3 Functions 20
- 9.4 Fault Behavior 21
- 11. Accessories 22
Xerox 1xx manuales
Manuales del propietario y guías del usuario para No Xerox 1xx.
Ofrecemos 1 manuales en pdf Xerox 1xx para descargar gratis por tipos de documentos: Manual de usuario
Komentarze do niniejszej Instrukcji